Connecting Border Gateways to Ethernet (PoE)
Connect the Border Gateway to a router using the Ethernet PoE (Power over Ethernet).
The Border Gateway provides a sealed RJ45 connector to attach an Ethernet cable to the device. The Ethernet connection provides a continuous power supply to the Border Gateway through the PoE Adapter, which is connected to a mains power supply. Deploy the Border Gateway as possible to the router and, ideally, on top of the building that houses the router.
-
Open the Ethernet connector by unscrewing the cap.
-
Disassemble the Ethernet connector, including the end cap, sealing ring and housing.
-
Lead the Ethernet cable through the end cap, sealing ring and housing.
-
Connect the Ethernet cable with the Ethernet socket in the connector.
-
Reassemble the connector. Carefully seat the sealing rings in the housing without damaging the barbs, then screw the end cap on the housing and screw the housing to the connector.
-
Connect the supplied Ethernet cable to the PoE (supplied).
-
Connect an Ethernet cable from the PoE to a router.
-
Plug in the PoE to a mains power supply.
Additional resources
- For more information about Border Gateway deployment scenarios using a PoE Adapter, see Setup with a PoE-ready router.