Mount Wildfire Sensors

Install sensors using treenails or garden wire, then let them calibrated for 14 days before they are ready to detect fires.

Confirm mounting in Deployment app

After the Registration successful message appears in the Deployment app. Brief instructions are provided for mounting correctly the Wildfire Sensor.

Tap Confirm.
After you have correctly mounted the Wildfire Sensor (see mounting instructions below) and is fully charged, an Installation successful message appears.

You can dismiss the dialog by tapping Close or you can view the Device Details by tapping Show Device Details.

Mount sensors using treenails (Long term)

Treenails are wooden pegs used to securely mount sensors to a tree. As they are made from wood, they do not affect the health of the tree. Over time the tree's moisture causes the treenails to expand which securely attaches the sensor to the tree.

Drill a 10 mm hole into the tree 3 m from the forest floor on the side of the tree where sunlight would strike the tree at 12:00 noon. The treenails are fed through a loop in the sensor and a spacer and then hammered into the tree.

With the help of an assistant, stabilize the ladder against the tree.
Locate the correct height (3 m) and direction (facing sun at 12:00 noon).
Carefully remove a small portion of the bark with an axe at that location. Try not to excessively damage the tree.

Carefully drill a hole approximately 6-7 cm into the tree using the 10mm drill bit. Do not drill deeper than this recommended depth to prevent unnecessary damage to the tree. When drilling into a hardwood tree, start with a smaller drill bit to drill a pilot hole then drill with the 10mm drill bit to complete the drill hole. Ensure you are using a drill bit for wood.

Insert a treenail through the sensor's loop, slip a spacer onto the treenail and then carefully hammer the treenail into the hole. Ensure the treenail is not damaged by the hammering.

Ensure the sensor is securely deployed to the tree and hanging loosely and vertically.

Mount sensors using garden wire (temporary only)

Sensors can be mounted using garden wire for short term installations. Garden wire is typically used in agricultural and garden settings such as greenhouses. This solution should only be used for a limited time as the wire will eventually interfere with growth in the tree's girth.